3D Design- Test Piece (Tower)

I printed out things for my sketchbook and tried to make a test

piece model using clear rods. I wanted to create one side of 
my Architecture model using clear rods, so I can shine light
through the bottom. It was hard to make the test piece, the rod I used for the test
piece was very thin, because the test piece is quiet small so it
would look best with the thin rods.(^∇^)

I am planning to use the foam board I got from College today to 
create some test models that are relevant to my design...

Taken with my camera 



The next day I used the photography studio to take images of my test 
piece that I made the day before...

If you cannot see the image above than please click on the area 
where the image suppose to be!! It will direct you to the image!!
THANKS!!