3D-Design

On Thursday in Matt's 3D Design lesson I was trying to sort my
Sketchbook out by gluing in the images for New York, of the museums
that had work which inspired me and also the buildings in New York.
 

I also did try to make some new test pieces using aluminium...
On Thursday morning also was using Google SketchUp to try and edit my
design of the building. I had a hard time trying to make curves , think
I am starting to hate the programme as it is a bit too "square" so it makes it
hard to draw curved buildings or depedning on what kind of design it is,
one cannot at all draw it in that programme which is my exact problem.

Got lots to do for my Final Major Project. Also will be editing my Final
Design of the building, as I thought I could make it much more interesting
(*^▽^*).

Well got Easter Holiday now, meaning I can do a lot of work during that time,
if I put my head into working mode!!

3D Design- Test Piece (Tower)

I printed out things for my sketchbook and tried to make a test

piece model using clear rods. I wanted to create one side of 
my Architecture model using clear rods, so I can shine light
through the bottom. It was hard to make the test piece, the rod I used for the test
piece was very thin, because the test piece is quiet small so it
would look best with the thin rods.(^∇^)

I am planning to use the foam board I got from College today to 
create some test models that are relevant to my design...

Taken with my camera 



The next day I used the photography studio to take images of my test 
piece that I made the day before...

If you cannot see the image above than please click on the area 
where the image suppose to be!! It will direct you to the image!!
THANKS!!